Hard Lump In Soft Palate

Lord of the rings custom Helmelt

Given the images of the slide show, bring on this occasion the painting process of this motorcycle helmet.

Preparing the surface with fine sandpaper, the number 360 to abrade the surface and promote paint adeherencia.

paper then parties do not want stained.

apply universal primary target diluted 100% a part of the first by a standart thinner. with 35 pounds of air outlet compressor to avoid as much as possible the breeze (oversprite)

Having applied the necessary layers of universal primary target once again sits the surface with sandpaper number 360, preferably one that is used for best results .

And if bed ready and painting, I begin to draw with a No. 2 pencil, trying not to stress too much the line, it is difficult to remove after just painting.

This airbrush in specific economic is of special flip-cup paint in different positioned himself. has a medium output point 2.5 but the fine line is achieved by reducing 150% paint. that as I have said above is acrylic automotive enamel.

Most of this drawing I made with a single tone paint but depending on how many layers of it is intensifying and darkening

After each color applied with a brush clean shake the remaining traces of paint as a breeze.

For continuity of this drawing I started to apply a base color yellow

and continuous

more racy colors in the scale of yellow, orange and red

ended with several layers of clear polyurethane. This material catalyzes a universal hardener quarter of the amount net to be applied, using no more than 35 pounds of air outlet of the compressor and preferably using a gravity gun automotive retouching.

Well here I leave this work done a few years old, waiting for their criticisms and opinions which will be welcome to improve every day.